Intermec WA21 System Manual page 136

Chapter 5 — Configuring the Spanning Tree
122
2 For each frame subtype field, check or clear the Allow/Pass check box
to configure if the frame subtypes are passed or are dropped. If you
check the check box, the frame subtype is allowed to pass.
3 In the SubType field, choose the customizable frame subtype. For help,
see the next table.
4 In the Value field, enter the two hex pairs. For help, see the next table.
5 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
Subtype Filter Descriptions
Subtype Value
DIX-IP-TCP-Port Port value in hexadecimal.
DIX-IP-UDP-Port Port value in hexadecimal.
DIX-IP-Protocol Protocol number in hexadecimal.
DIX-IPX-Socket Socket value in hexadecimal.
DIX-EtherType Specify the registered DIX type in hexadecimal.
SNAP-IP-TCP-Port Port value in hexadecimal.
SNAP-IP-UDP-Port Port value in hexadecimal.
SNAP-IP-Protocol Port value in hexadecimal.
SNAP-IPX-Socket Socket value in hexadecimal.
SNAP-EtherType SNAP type in hexadecimal. To filter on both SNAP type and
OUI, use advanced filters.
802.3-IPX-Socket Socket value in hexadecimal.
802.2-IPX-Socket Socket value in hexadecimal.
802.2-SAP 802.2 SAP in hexadecimal.
MobileLAN access WA2X System Manual