Intermec WA21 System Manual page 243

Example: To erase the contents of the flash memory segment, enter:
Purpose: Runs a program
Syntax:
Example: To run program UAPBOOT.PRG from the flash memory segment, enter:
Purpose: Reinitializes the access point file system. If the access point file system or a
Syntax:
Purpose: Downloads a file using Ymodem batch protocol into the flash segment
Syntax:
Purpose: Loads the FPGA configuration file into the access point. If you are
Syntax:
MobileLAN access WA2X System Manual
FE 1
To erase the contents of the memory card, enter:
FE APP:
FFR
, from a location
f
FFR f (s)
where:
f is the program name.
s is the optional segment location of the program.
FFR UAPBOOT.PRG 1
FI
file segment becomes corrupt, use this command to reset it.
FI (s)
where s is the optional number of the segment to be reinitialized. You can
use any segment number (1, 2, 3, or 4) to specify the one flash memory
segment on the WA2X.
FX
that is specified by .
s
FX s
where s is destination segment. You can use any segment number (1, 2, 3,
or 4) to specify the one flash memory segment on the WA2X.
HDW
directed to change the FPGA firmware in the access point, use this
command.
HDW f (s)
where:
f is the FPGA configuration filename.
s is the optional segment where you want to load the configuration
file.
Chapter 9 — Additional Access Point Features
.
s
229