Intermec WA21 System Manual page 253

Purpose: Sets the internal variable terminate to a specified value. Use terminate to
Syntax:
Purpose: Sets the setactivepointers command to change inactive segments to active
Syntax:
Example: To change the inactive boot and data segments to active at the next
MobileLAN access WA2X System Manual
When the software download is started, you can use SNMP to query its
progress by reading the checkpoint variable. If the variable has a value of 2,
you know that the access point is trying to execute the TFTP get
statement. If the value is 3, you know the script has completed and the
reboot was executed. The value of the checkpoint variable may also be
helpful in determining where an error occurred if the script fails.
sdvars set terminate
stop a countdown process in the access point. If either starttime or
nextpoweruptime is counting down, setting this variable stops the timer
and halts the countdown process.
Note: You should use caution when using this command. If the script file
is being downloaded or executed, setting this variable interrupts the
processing and can leave the access point in an undetermined state that
may require user intervention.
sdvars set terminate
sdvars set setactivepointers
segments the next time the access point is rebooted. This command is
usually used with the nextpoweruptime command.
sdvars set setactivepointers none/boot/data/both
where:
none does not change the active segments. The default is
Also, when the reboot is completed, the access point resets
this value to
boot changes the inactive boot segment to the active boot segment.
data changes the inactive data segment to the active data segment.
both changes both the boot and data inactive segments to the
active segments.
reboot, enter:
sdvars set setactivepointers both
Chapter 9 — Additional Access Point Features
.
none
none.
239