Intermec WA21 System Manual page 104

Chapter 4 — Configuring the Radios
90
To configure 802.11b radio inbound filters
1 From the main menu, click 802.11b Radio > Advanced
Configuration > Inbound Filters. The Inbound Filters screen appears.
2 For each frame type, check or clear each check box. For help, see the
next table.
3 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
802.11b Radio Inbound Filter Descriptions
Parameter Description
Allow IAPP Determines if this radio accepts IAPP (Inter Access Point
Protocol) frames from other access point station radios. The
IAPP frames must match Ethernet protocol 875c.
Allow Wireless Determines if this radio accepts WTP frames from end devices.
Transport Protocol The WTP frames must match Ethernet protocol 875b.
(WTP)
Allow SpectraLink Determines if this radio accepts SVP frames from SpectraLink
Voice Protocol (SVP) wireless telephones. The SVP frames must match IP 119.
Allow UDP Plus Determines if this radio accepts UDP Plus frames from end
(UDP/IP Port 5555) devices. The UDP Plus frames must match the UDP network
port 5555 on the DCS 30X, Intermec Gateway, or ARP.
Allow DHCP Determines if this radio accepts DHCP frames. The DHCP
frames must match UDP destination port 67 and ARP. Check
this check box if the end devices are DHCP clients.
Allow All Other Determines if this radio accepts all other protocols that are not
Protocols filtered by one of the filters in this screen.
MobileLAN access WA2X System Manual