Chapter 3 — Configuring the Ethernet Network
52
Note: You cannot configure the access point as both a DHCP server and a
DHCP client.
Note: If you are using the embedded authentication server feature, do not
configure the access point as a DHCP client.
To configure the access point as a DHCP client
1 From the menu, click TCP/IP Settings. The TCP/IP Settings screen
appears.
2 Configure the DHCP parameters to make this access point a DHCP
client. For help, see the next table.
Note: If you set DHCP Mode to Disable DHCP and the IP address for
this access point is 0.0.0.0, all IP communications are disabled for this
access point.
3 Click Submit Changes to save your changes. To activate your changes,
from the menu bar click Save/Discard Changes, and then click Save
Changes and Reboot. For help, see "Saving Configuration Changes"
on page 33.
MobileLAN access WA2X System Manual