Chapter 8 — Managing, Troubleshooting, and Upgrading Access Points
198
MobileLAN access LED Boot Sequence for Release 2.2 (or later)
Wireless
Wireless
Power
#1
#2
(Wireless #1 and #2
blink in unison.)
= On
= Off
After the WA22 successfully boots, the LEDs display one of these patterns:
WA2XB Normal LED Pattern After Booting
(Blinks for wireless
data traffic.)
WA2XA Normal LED Pattern After Booting
(Blinks for wireless
data traffic.)
or
Ready-to-
Wired
Work or
LAN
Root/error
= Blinking
(Blinks if a radio
(Blinks for wired
is installed.)
data traffic.)
(Blinks if a radio
(Blinks for wired
is installed.)
data traffic.)
MobileLAN access WA2X System Manual
Description
Checksum Test starts
Checksum Test fails
Monitor Load
PCI Bus Test starts
PCI Bus Test fails
RAM Test starts
RAM Test fails
Only Boot ROM
code is available on
access point. Load
new files.
(Blinks if the
access point
becomes root.)