MobileLAN access WA2X System Manual
7 Press Enter to access the TCP/IP Settings menu.
8 If you are not using a DHCP server, you need to manually assign an IP
address. Configure these parameters in the TCP/IP Settings menu:
IP Address
IP Subnet Mask
IP Router (Gateway)
Or, if you are using a DHCP server to automatically assign an IP
address to your access point, configure these parameters in the TCP/IP
Settings menu:
DHCP Mode
DHCP Server Name
9 Press Esc to return to the Access Point Configuration menu.
10 Choose Save Configuration.
11 Choose Reboot.
When the access point is done rebooting, you are ready to install the access
point in your network. See Chapter 2, "Installing the Access Points."
A unique IP address.
The subnet mask that matches the other devices in your
network.
If the access point will communicate with devices on
another subnet, enter the address of the router that will
forward frames.
Set to <Use DHCP if IP Address is Zero>.
The name of the DHCP server that the access point is to
access for automatic address assignment. If no server
name is specified, the access point responds to offers from
any server.
Chapter 1 — Getting Started
29