Intermec WA21 System Manual page 209

Alphabetized List of Configuration Error Messages (continued)
Configuration Error Message
A RADIUS server entry points at this access point but the shared secret does
not match that of the Embedded Authentication Server.
A RADIUS server entry points at this access point but the UDP port number
does not match that of the Embedded Authentication Server.
A secure service set is available, but wireless hops are allowed on an insecure
service set.
A username/password entry in the RADIUS database has a password but no
username.
A username/password entry in the RADIUS database has a username but no
password.
All SSID values must be unique per physical radio.
An entry in the RADIUS server list is using a default secret key.
At least one 802.1x supplicant protocol must be enabled.
Matching WEP keys will merge VLAN multicast.
No RADIUS servers have been configured for 802.1x authentication.
No RADIUS servers have been configured for ACL authorization.
No RADIUS servers have been configured for login authorization.
The 802.1x username and password have not been changed from their default
values.
The access point is set to originate IP tunnels but no there are no tunnel IP
addresses.
MobileLAN access WA2X System Manual
Chapter 8 — Managing, Troubleshooting, and Upgrading Access Points
Additional Information
The Default Secret Key for the EAS
does not match the secret key value
in the RADIUS Server List. For
help, see "Enabling the EAS" on
page 168.
The UDP port number in the EAS
does not match the port number
entered in the RADIUS Server List.
For help, see "Enabling the EAS" on
page 168.
While configuring multiple service
sets, you did not specify a unique
SSID (network name) for each
service set. For help, see
"Configuring the 802.11g Radio" on
page 76 or "Configuring the 802.11a
Radio" on page 92.
Intermec recommends that you
change the secret key from the
default for security reasons.
Click the message and check the
802.1x check box for at least one
server in the RADIUS Server List.
Click the message and check the
ACL check box for at least one server
in the RADIUS Server List.
Click the message and check the
Login check box for at least one
server in the RADIUS Server List.
On the IP Tunnels screen, Mode is
set to Originate if Root, but no IP
addresses have been added to the IP
Addresses screen. Either change the
mode or add some addresses. For
help, see "Configuring IP Tunnels"
on page 116 and "Configuring the
IP Address List" on page 117.
195