3Com 4210G Series Configuration Manual page 777

Configure Device B as you configure Device A.
3) Verifying the configurations
You can use the display dldp command to display the DLDP configuration information on ports.
# Display the DLDP configuration information on all the DLDP-enabled ports of Device A.
[DeviceA] display dldp
DLDP global status : enable
DLDP interval : 6s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : auto
DLDP delaydown-timer : 2s
The number of enabled ports is 2.
Interface GigabitEthernet1/0/50
DLDP port state : disable
DLDP link state : down
The neighbor number of the port is 0.
Interface GigabitEthernet1/0/51
DLDP port state : disable
DLDP link state : down
The neighbor number of the port is 0.
The output information indicates that both GigabitEthernet 1/0/50 and GigabitEthernet 1/0/51 are in
Disable state and the links are down, which means unidirectional links are detected and the two ports
are thus shut down.
Correct the fiber connections after detecting the problem, and perform the following operations:
# Reset DLDP state for the ports shut down by DLDP.
[DeviceA] dldp reset
# Display the DLDP configuration information on all the DLDP-enabled ports of Device A.
[DeviceA] display dldp
DLDP global status : enable
DLDP interval : 6s
DLDP work-mode : enhance
DLDP authentication-mode : none
DLDP unidirectional-shutdown : auto
DLDP delaydown-timer : 2s
The number of enabled ports is 2.
Interface GigabitEthernet1/0/50
DLDP port state : advertisement
DLDP link state : up
The neighbor number of the port is 1.
Neighbor mac address : 0000-0000-0101
Neighbor port index : 59
Neighbor state : two way
4-14