Nqa Collaboration Configuration Example - 3Com 4210G Series Configuration Manual

NQA Collaboration Configuration Example

Network requirements
As shown in Figure
hop. Associate the static route, track entry, and NQA test group to verify whether static route is active
in real time.
Figure 24-13 Network diagram for NQA collaboration configuration example
Vlan-int3
10.2.1.1/24
Vlan-int3
10.2.1.2/24
Switch A
Configuration procedure
1) Assign each interface an IP address. (omitted)
2) On Switch A, configure a unicast static route and associate the static route with a track entry.
# Configure a static route, whose destination address is 10.2.1.1, and associate the static route with
track entry 1.
<SwitchA> system-view
[SwitchA] ip route-static 10.1.1.2 24 10.2.1.1 track 1
3) On Switch A, create an NQA test group.
# Create an NQA test group with the administrator name being admin and operation tag being test.
[SwitchA] nqa entry admin test
# Configure the test type of the NQA test group as ICMP echo.
[SwitchA-nqa-admin-test] type icmp-echo
# Configure the destination IP address of the ICMP echo test operation as 10.2.1.1.
[SwitchA-nqa-admin-test-icmp-echo] destination ip 10.2.1.1
# Configure the interval between two consecutive tests as 100 milliseconds.
[SwitchA-nqa-admin-test-icmp-echo] frequency 100
# Create collaboration entry 1. If the number of consecutive probe failures reaches 5, collaboration
with other modules is triggered.
[SwitchA-nqa-admin-test-icmp-echo] reaction 1 checked-element probe-fail threshold-type
consecutive 5 action-type trigger-only
[SwitchA-nqa-admin-test-icmp-echo] quit
# Configure the test start time and test duration for the test group.
[SwitchA] nqa schedule admin test start-time now lifetime forever
4) On Switch A, create the Track entry.
# Create Track entry 1 to associate it with Reaction entry 1 of the NQA test group (admin-test).
24-13, configure a static route to Switch C on Switch A, with Switch B as the next
Switch B
Vlan-int2
10.1.1.1/24
Vlan-int2
10.1.1.2/24
Switch C
23-38