When the device functions as the SFTP server, only one client can access the SFTP server at a time.
If the SFTP client uses WinSCP, a file on the server cannot be modified directly; it can only be
downloaded to a local place, modified, and then uploaded to the server.
Configuring the SFTP Connection Idle Timeout Period
Once the idle period of an SFTP connection exceeds the specified threshold, the system automatically
tears the connection down, so that a user cannot occupy a connection for nothing.
Follow these steps to configure the SFTP connection idle timeout period:
To do...
Enter system view
Configure the SFTP
connection idle timeout period
Configuring an SFTP Client
Specifying a Source IP Address or Interface for the SFTP Client
You can configure a client to use only a specified source IP address or interface to access the SFTP
server, thus enhancing the service manageability.
Follow these steps to specify a source IP address or interface for the SFTP client:
To do...
Enter system view
Specify a
source IP
address or
interface for
the SFTP
client
Establishing a Connection to the SFTP Server
This configuration task is to enable the SFTP client to establish a connection with the remote SFTP
server and enter SFTP client view.
Follow these steps to enable the SFTP client:
Use the command...
system-view
sftp server idle-timeout
time-out-value
Use the command...
system-view
Specify a
sftp client source { ip
source IPv4
ip-address | interface
address or
interface-type
interface for the
interface-number }
SFTP client
Specify a
source IPv6
sftp client ipv6 source
{ ipv6 ipv6-address |
address or
interface for the
interface interface-type
interface-number }
SFTP client
—
Optional
10 minutes by default
—
Required
Use either command.
By default, an SFTP client uses
the interface address specified
by the route of the device to
access the SFTP server.
9-2
Remarks
Remarks