3Com 4210G Series Configuration Manual page 608

For detailed configuration of a DHCP server, refer to DHCP Configuration in the IP Service Volume.
Network diagram
Figure 7-2 Network diagram for configuring dynamic binding function
Configuration procedure
1) Configure Switch A
# Configure dynamic binding function on port GigabitEthernet 1/0/1.
<SwitchA> system-view
[SwitchA] interface gigabitethernet1/0/1
[SwitchA-GigabitEthernet1/0/1] ip check source ip-address mac-address
[SwitchA-GigabitEthernet1/0/1] quit
# Enable DHCP snooping.
[SwitchA] dhcp-snooping
# Configure the port connecting to the DHCP server as a trusted port.
[SwitchA] interface gigabitethernet 1/0/2
[SwitchA-GigabitEthernet1/0/2] dhcp-snooping trust
[SwitchA-GigabitEthernet1/0/2] quit
2) Verify the configuration
# Display dynamic binding function is configured successfully on port GigabitEthernet 1/0/1.
[SwitchA] interface gigabitethernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] display this
#
interface GigabitEthernet1/0/1
ip check source ip-address mac-address
#
return
# Display the dynamic binding entries that port GigabitEthernet 1/0/1 has obtained from DHCP
snooping.
[SwitchA-GigabitEthernet1/0/1] display ip check source
Total entries found: 1
MAC IP
0001-0203-0406 192.168.0.1
# Display the dynamic entries of DHCP snooping and check it is identical with the dynamic entries that
port GigabitEthernet 1/0/1 has obtained.
Vlan Port
1 GigabitEthernet 1/0/1
7-5
Status
DHCP-SNP