3Com 4210G Series Configuration Manual page 874

[Sysname-luser-test] password cipher 123
[Sysname-luser-test] service-type telnet
After the above configuration, when users telnet to the device through VTY 1, they need to input
username test and password 123. After passing the authentication, users can only use the commands
of level 0. If the users need to use commands of levels 0, 1, 2 and 3, the following configuration is
required:
[Sysname-luser-test] authorization-attribute level 3
3) Configure the user privilege level under a user interface
If the user interface authentication mode is scheme when a user logs in, and SSH publickey
authentication type (only username is needed for this authentication type) is adopted, then the user
privilege level is the user interface level; if a user logs in using the none or password mode (namely,
no username is needed), the user privilege level is the user interface level.
Follow these steps to configure the user privilege level under a user interface (SSH publickey
authentication type):
To do...
Configure the authentication
type for SSH users as
publickey
Enter system view
Enter user interface view
Configure the authentication
mode when a user uses the
current user interface to log in
to the device
Configure the privilege level of
the user logging in from the
current user interface
Follow these steps to configure the user privilege level under a user interface (none or password
authentication mode):
To do...
Enter system view
Enter user interface view
Configure the authentication
mode when a user uses the
current user interface to log in
to the device
Use the command...
For the details, refer to SSH2.0
Configuration in the Security
Volume.
system-view
user-interface [ type ]
first-number [ last-number ]
authentication-mode scheme
[ command-authorization ]
user privilege level level
Use the command...
system-view
user-interface [ type ]
first-number [ last-number ]
authentication-mode { none |
password }
9-11
Remarks
Required if users adopt the
SSH login mode, and only
username, instead of password
is needed at authentication.
After the configuration, the
authentication mode of the
corresponding user interface
must be set to scheme.
—
—
Optional
By default, the authentication
mode for VTY and AUX user
interfaces is password.
Optional
By default, the user privilege
level for users logging in from
the console user interface is 3,
and that for users logging from
the other user interfaces is 0.
Remarks
—
—
Optional
By default, the authentication
mode for VTY and AUX user
interfaces is password.