Configuring Web User Accounts In Batches - 3Com 4210G Series Configuration Manual

24-port/48-port
Hide thumbs Also See for 4210G Series:
Table of Contents

Advertisement

The SNMP-related configurations are retained when a cluster is dismissed or the member devices
are removed from the whitelist.
For information about SNMP, refer to SNMP Configuration in the System Volume.

Configuring Web User Accounts in Batches

Configuring Web user accounts in batches enables you to configure on the management device the
username and password used to log in to the devices (including the management device and member
devices) within a cluster through Web and synchronize the configurations to the member devices in the
whitelist. This operation is equal to performing the configurations on the member devices. You need to
enter your username and password when you log in to the devices (including the management device
and member devices) in a cluster through Web.
Follow these steps to configure Web user accounts in batches:
To do...
Enter system view
Enter cluster view
Configure Web user accounts
in batches
If a cluster is dismissed or the member devices are removed from the whitelist, the configurations of
Web user accounts are still retained.
Use the command...
system-view
cluster
cluster-local-user username password
{ cipher | simple } password
26-18
Remarks
Required

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

4210g nt4210g pwr

Table of Contents