Table of Contents
Advertisement
To check the current status use the format XB[ ]
The response will be
To change the status of level scan ON / OFF use the format:
XBn[ ]
where n = 0 level scan OFF
Related commands BM ML XA XD XM XO XP XQ
XD
Scan delay time.
The XD command is used to check and set the scan delay time.
To check the current setting use the format: XD[ ]
The response will be XDnn where nn = time incremented in tenths of seconds
(100mS), the value of nn is between 00 ~ 9.9 When nn = 00 scan delay is OFF.
For example a response of XD5.2 would indicate scan delay time is set to 5.2
seconds while a response of XD00 indicates that scan delay is OFF.
To change the setting of scan delay time use the format:
XDnn[ ] where nn = 00 ~ 9.9
The value being incremented in tenths of seconds (100mS) and 00 being scan
delay OFF.
Related commands BM ML XA XB XM XO XP XQ
XB0 = level scan OFF
XB1 ~ XB7 = level scan ON
n = 1 ~ 7 level scan ON
for example SB3 means level scan set to
threshold 3
- 47 -
XB : XD
Advertisement
Table of Contents
