Table of Contents
Advertisement
MS : MX
MS
Start memory scan.
The MS command places the receiver into memory scan mode.
MS[ ]
Commences memory scan from the current memory bank (or last one used if in
another operating mode).
MSx[ ]
Commences memory scan from a specified memory bank number
where x = A ~ J & a ~ j memory bank number
Related commands BM BN DD MG ML MP MQ MR MX SG SS VF XA VB XD XM
XO XP XQ
MX
Write data into a memory channel.
The MX command is used to write a comprehensive set of data to a specified
memory bank / channel.
The format of the command is:
MXxnnRF[freq]_AU[auto mode]_ST[step size]_MD[mode]_AT[att]_TM[text] [ ]
For example: MXD12_RF124.8_AU1_AT0_TMAirband [ ]
This will set memory bank "D" channel "12" to 124.8 MHz, Auto mode ON,
Attenuator OFF and text "Airband".
Always start with MX and end with TM followed by [ ]. Each command is
separated with a space _ .
MXxnn Memory location where
RFnnnnnnnnm0 (Hz)
x = A ~ J & a ~ j memory bank
nn = 00 ~ 49 memory channel
Frequency input frequency in Hz. The last but one
digit (tens of Hz) MUST be either "5" or "0".
- 28 -
Advertisement
Table of Contents
