AOR CU8232 Manual page 18

BN : BQ : BS
BN
The BN command is used to change the starting point for SCAN and SEARCH
banks. In VFO mode, BN specifies the bank to use when SCAN or SEARCH
mode is entered (rather than the last used bank location).
In scan or search mode for format is BNx[ ] where x is a bank location A-J & a-j.
To review the current status of BN simply type BN[ ]
The response is split into SEARCH and SCAN banks, MXx for SCAN bank and
SRx for SEARCH bank. For example "SRD" indicates search bank D and MXj
indicated scan bank j.
Related commands BM BQ BS ML MQ
BQ
Switch search bank link On/Off (globally).
The BQ command provides a simple method of switching search bank link On/Off.
Type BQn[ ] to toggle the status
Related commands BN BS SA SB SD SG SO SP SS
BS
SEARCH BANK LINK ON/OFF (specifically).
BS[ ] checks the current status of linked search banks.
If bank letters are specified then search bank link is On (the specified banks will
be searched as a group), if no letters are specified then the facility is Off.
First check the current status by typing BS[ ]
A typical response may be: BS -BC—F-HIJa—e——j
To switch bank link Off type in the reported scan bank letters
BS BCFHIJaej (lower case input being accepted for the second group of memory
banks)
n = 0 search bank link OFF
n = 1 search bank link ON
- 18 -