AOR CU8232 Manual page 37

SE
The SE command is used to input data for search bands.
To write search data into the currently selected search bank, the format of the SE
command is:
SE_SL[LOWER FREQUENCY]_SU[HIGHER FREQUENCY]_AU[AUTOMODE]_
ST[STEP SIZE]_MD[MODE]_AT[ATTENUATOR]_TT[TEXT][ ]
To write search date to a specific search bank, the following format is used:
SEx_SL[LOWER FREQUENCY]_SU[HIGHER FREQUENCY]_AU[AUTOMODE]_
ST[STEP SIZE]_MD[MODE]_AT[ATTENUATOR]_TT[TEXT][ ]
Where:
SEx
SL
SU
AU
ST
MD
AT
TT
A typical input may look like:
SEC_SL0118500000_SU0135900000_AU1_(ST025000_MD2_)AT0_TTAIR.VHF[ ]
The input in brackets ( ) is ignored when automode is selected ON.
Related commands SR SG SS
x = Search bank number A ~ J or a ~ j
Lower frequency limit nnnnnnnnm0 (Hz)
or
m = "0" or "5" (tens of Hz position)
Upper frequency limit nnnnnnnnm0 (Hz)
or
m = "0" or "5" (tens of Hz position)
Automode n = 0 Automode OFF
n = 1 Automode ON
When automode is ON, the receive mode and step
size is automatically set and any alternative input
of SE will be ignored. Refer to AU command.
Step size
or
m = "0" or "5" (tens of Hz position)
Receive mode WFM
NFM
AM
USB
LSB
CW
Attenuator n = 0 Attenuator OFF
n = 1 Attenuator ON
Text comment - Up to 7 ASCII characters or
characters available in the list (see list under "TT"
command and further detail under TM command)
- 37 -
nnnn.nnnnm (MHz)
nnnn.nnnnm (MHz)
nnnnm0 (Hz)
nnn.nm (kHz)
0
1
2
3
4
5
SE