AOR CU8232 Manual page 39

SL
Set the lower frequency of a search bank.
This command cannot be used on its' own but must be used in conjunction with
the SE command, please refer to the section on SE.
SL Lower frequency limit
m = "0" or "5" (tens of Hz position), "0" must always be "0" any other entry will be
ignored. Input below 1.6 MHz is displayed in kHz.
Related commands SE SL SU TT
SM
Start memory scan.
The SM command is used to start a memory scan. The format of the command is
SM[ ]
Related commands GA GD GR
SN
Select PASSWORD options.
The SN command is used to set or disable the PASSWORD protection of the
memory and search banks a ~ j.
To review the current password use the format SN[ ]
The response will be in the format SNnnnn where nnnn is the four digit
password. If the response is "0000" then the password facility is disabled.
To set a new password use the format SNnnnn[ ] where nnnn is a four digit
number comprising of digits 0 ~ 9 inclusive. To disable the password use the
command SN0000[ ]
nnnnnnnnm0 (Hz)
or
nnnn.nnnnm (MHz)
- 39 -
SL : SM : SN