AOR CU8232 Manual page 42

SS : ST
SS
Engage search mode - start search.
The SS command is used to start the search process from either the current or
specified search bank.
To start searching from the current search bank use the format SS[ ]
To start searching from a specified search bank use the format SSx[ ]
where
x = search bank A ~ J or a ~ j.
Related commands DD MR MS RX SG VF
ST
Tuning step size.
The ST command is used in conjunction with several other commands to set the
tuning or search increment. Multiple command entry is possible with AT, AU, MD,
RF, ST, VA & VB (with a space separating each command).
The format of the command is ST nnnnm0[ ] (Hz)
m = "0" or "5" (tens of Hz position), "0" must always be zero - any other entry will
be ignored. Any step size is possible in multiples of 50 Hz up to 999.995 kHz.
Note: When step size is entered AUTOMODE is automatically switched OFF.
To view the current setting of step size use the command ST[ ]
A typical response may be ST020000 which would be 20 kHz.
A typical multiple command may be AU0_MD3_RF145.2_ST010.[ ]
Related commands AU MD MX RF SE VA VB
or
ST nnn.nm[ ] (kHz)
- 42 -