AOR CU8232 Manual page 30

PA : PD
PA
Set delay time for power save mode.
The PA command is used to set the delay time and is used in conjunction with PI
which sets the interval time for the power save facility.
The command PA[ ] checks the current setting of power save delay time, the
response being PAnn where
To change the current setting, use the PA command followed by a two digit
numeric value between 00 ~ 99. The value is in seconds and "00" switched the
power save facility off (please refer to page 97 section 16 of the AR8000 English
language operating manual).
To set a delay of 12 seconds use the command PA12[ ]
Related command PI
PD
Delete PASS frequencies in search mode.
There are 50 PASS frequencies allocated per search bank, they may be deleted
on an individual basis or the whole bank may be deleted in one go.
The BN or SS commands must be used to choose the bank prior to using the PD
command.
PDnn[ ] deletes a specific PASS frequency from the chosen search bank
where nn is the PASS channel number 00 ~ 49.
When a PASS channel is deleted, the PASS frequency number will be
incremented upward.
PD%%[ ] deletes ALL PASS channels from the current search bank in one go.
Related commands BN PR PS PW SG SR SS
nn = 01 ~ 99 seconds
nn = 00 is power save OFF
- 30 -