AOR CU8232 Manual page 45

characters or characters from the table (see TM) may be entered. Blank table
entries [ ] represent a blank space.
TTxxxxxxx
Related commands SE SR
VA VB
Check and change the receive frequency of VFOA or VFOB.
The VB and VB commands may be used to read the current frequency from
VFOA or VFOB and to write a new receive frequency. Both commands are used
in the same manner, VA addressing VFOA and VB addressing VFOB.
To read the current receive frequency of VFO A use the format VA[ ]
A typical response may be:
VA0001134000_ST009000_AU1_MD2_AT0
2VFO MODE VFO A, receive frequency 1.134 MHz, channel step size 9 kHz,
automode ON, receive mode AM, attenuator OFF.
To read the current receive frequency of VFO B use the format VB[ ]
A typical response may be:
VB0145040000_ST020000_AU1_MD1_AT0
To write a new frequency to VFO A and switch to 2VFO mode use the format:
VAnnnnnnnnm0 (Hz)
VA nnnn.nnnnm (MHz)
where m = "0" or "5" in the 10Hz position. "0" in the Hz position is always "0", any
other value will be ignored. Frequencies below 1.6 MHz are displayed as kHz.
A typical input to write a new frequency of 433.250 MHz to VFO B would be:
VB433.25[ ]
Multiple command entry is possible (using AT, AU, MD, RF, ST) with a space
separating each command: AU0_MD3_VB433.2[ ]
Related commands AT AU MD RF ST VA VB
Text write where xxxxxxx may be up to 7
characters in ASCII or character mode. Entry is
completed with a [ ]
- 45 -
TT : VA : VB