AOR CU8232 Manual page 43

SU
Set the upper frequency of a search bank.
This command cannot be used on its' own but must be used in conjunction with
the SE command, please refer to the section on SE.
SU Upper frequency limit
m = "0" or "5" (tens of Hz position), "0" must always be "0" any other entry will be
ignored. Input below 1.6 MHz is displayed in kHz.
Related commands SE SL TT
TI
Priority interval time.
The TI command is used to set the priority interval time (how long to wait between
checking the priority channel for activity).
To check the current setting use the format TI[ ]
The response will be TInn where nn = 01 ~ 19 seconds.
A typical response may look like TI13
To change the timing use the format TInn[ ] where nn = 01 ~ 19 seconds.
nnnnnnnnm0 (Hz)
or
nnnn.nnnnm (MHz)
- 43 -
SU : TI