Table of Contents
Advertisement
VF : XA : XB
VF
Switch to 2VFO mode.
The VF command is used to place the receiver into 2VFO mode. The data from
the current VFO (A or B) is automatically reported.
Use the command VF[ ]
A typical response may be: VA0433040000_ST0200000_AU1_MD1_AT0
The date representing 2VFO mode, VFOA active, receive frequency 433.04 MHz,
20 kHz channel step, Automode ON, receive mode NFM, attenuator ON.
Another response may be (for VFOB): VB0145080000_ST020000_AU1_MD1_AT0
Related commands DD MR MG MS SM SG SS VA VB
XA
Audio scan ON / OFF.
The XA command is used to check the current setting of audio scan mode and
change the status as required.
To check the current status use the format XA[ ]
The response will be
To change the status of audio scan ON / OFF use the format:
XAn[ ]
where n = 0 audio scan OFF
Related commands BM ML XB XD XM XO XP XQ
XB
Level scan ON / OFF.
The XB command is used to check the current setting of level scan mode and
change the status as required.
XA0 = audio scan OFF
XA1 = audio scan ON
n = 1 audio scan ON
- 46 -
Advertisement
Table of Contents
