AOR CU8232 Manual page 25

MG
Scan with frequency and S-meter then resume.
The MG commands causes an automatic response of receive frequency and
S-meter level (similar to LC command) AND places the receiver into memory scan
mode again.
MG[ ] will report the present receive frequency in Hz and S-meter. The S-meter
report is in 64 steps from hex decimal 00 to 3F.
A typical response may be:
S-meter h2B Receive frequency 145.30 MHz
Related commands BM BN DD ML MP MQ MR MS MX SG SS VF XA VB XD XM
XO XP XQ
ML
Scan bank link On/Off.
The ML command is used to switch the memory scan bank link facility ON / Off.
The command ML[ ] may be used to check the current status of scan bank link.
To change the status of scan bank link, the MLn[ ] command is used
where
Related commands BM BN XA XB XD XM XO XP XQ
LC2B_RF0145300000
n = 0 Bank link OFF
n = 1 Bank link ON
- 25 -
MG : ML