Table of Contents
Advertisement
SQ
Check the search options (level & audio).
The SO command is used to check the current setting of search parameters.
Use the command SQ[ ]
The response will be
Related commands SA SB SD SO SP BS BQ
SR
Recall search data.
The SR command is used to recall search data for a chosen bank.
To recall the search data from the currently selected search bank use the format
SR[ ]
To recall the search data from a specific bank use the format SRx[ ]
where
x = search bank A ~ J or a ~ j.
A typical response may be:
SRC_SL0118500000_SU0135900000_ST025000_AU1_MD2_AT0_TTAIR.VHF
This is a data breakdown of:
Search bank
Lower (start) frequency
Upper (end) frequency
Automode
Attenuator
Text
Related command SE
SQ0 = Not engaged
SQ1 = Level search ON
SQ2 = Audio search ON
SQ3 = BOTH level & audio search ON
C
118.50 MHz
135.90 MHz
ON (this means that mode & step are ignored so
do not have to be specified as will be taken
from the receivers preprogrammed data)
OFF
AIR.VHF
- 41 -
SQ : SR
Advertisement
Table of Contents
