AOR CU8232 Manual page 26

MP : MQ
MP
Register the present channel as PASS.
The MP command is used to register the current memory channel as PASS
(so that it will be skipped during scan). The command is generally used in
conjunction with the "MR" command.
To check the current status of PASS use the command MP[ ]
The response will be
It is possible to change the status of memory channel PASS using the command:
MPn[ ] where n = 0 Channel PASS OFF
n = 1 Channel PASS ON
Related commands BN MQ MR MG MS
MQ
Delete the current memory channel OR bank.
The MQ command can only be used in M.RE (memory read) mode. It is used
to delete memory channels or a whole memory bank in one go. The memory bank
must first be recalled as the active bank.
Note: One memory channels have been deleted the data is lost. They can not be
reinstated but new data has to be written to the channel if required.
The command MQ[ ] deleted the current memory channel.
The command MQnn[ ] deletes the specified memory channel from the current
bank were nn = 00 ~ 49
The command MQ%%[ ] deletes ALL memory channels from the current memory
bank.
Related commands BN MP MR MG MS
MP0 Memory PASS OFF
MP1 Memory PASS ON
- 26 -