Table of Contents
Advertisement
Connection & clone
The [PROGRAM] socket is the primary receiver connection used for computer
control. This port also takes power from the receiver (when the AR8000 is
switched On).
Should you wish to CLONE data between two AR8000 receivers, connect the
second ribbon cable to the socket labelled [COPY].
2. Remove the battery compartment lid of the AR8000 using a downward sliding
motion.
Figure 2
Locate the remote control socket which is located at the bottom edge of the
battery compartment. Insert the ribbon cable (with the reinforced plate) contact
(metal) side downward.
Figure 3
Figure 1
- 4 -
Advertisement
Table of Contents
