Table of Contents
Advertisement
SG : SI
SG
Search with frequency and S-meter then resume.
The SG commands causes an automatic response of receive frequency and
S-meter level (similar to MG / LC command) AND places the receiver into search
mode again.
SG[ ] will report the present receive frequency in Hz and S-meter. The S-meter
report is in 64 steps from hex decimal 00 to 3F starting from the currently selected
search bank.
A typical response may be:
S-meter h2B Receive frequency 145.30 MHz
The command SGx[ ] causes an automatic response and searching from the
specified bank where x = A ~ J & a ~ j.
Related commands LC MG SS
SI
Set code for option ON / OFF (not available in the UK).
The SI command is used to review and select the optional code unit On / Off if the
option is fitted to the AR8000.
To review the current status use the command SI[ ]
The response will be in the format SIn
To switch the code option ON / OFF use the format SIn[ ]
Related command SC
LC2B_RF0145300000
where
n = 0 Optional code unit OFF
n = 1 Optional code unit ON
where
SI0[ ] = Optional code unit OFF
SI1[ ] = Optional code unit ON
- 38 -
Advertisement
Table of Contents
