Table of Contents
Advertisement
LC : LM
LC
The LC command caused the receiver to supply FREQUENCY and S-METER
level only when the squelch is opened. A new response will be repeated
automatically when the squelch is closed and opened again.
The automatic data response will only be supplied when ALL squelch parameters
are met (level scan, audio scan etc).
To terminate the facility send another command.
LC[ ] will report the present receive frequency and S-meter. The S-meter report
is in 64 steps from hex decimal 00 to 3F.
A typical response may be:
1VFO S-meter h1B Receive frequency 145.30 MHz
Another example:
2VFO VFOA S-meter h04 Receive frequency 128.80 MHz
Notes: S-meter reading and frequency are separated with a space. The S-meter
output is in 64 steps (hex decimal) 00 to 3F. "3F" may not be available on some
sets as he CPU processes the data and the MAXIMUM level may vary slightly
between sets.
Approximate relation of S-meter and LC report:
S-meter
0
1
"LC"
0 ~ 04 ~ 08 ~ 0C ~ 10 ~ 14 ~ 18 ~ 1C ~ 3F (16 hex)
Related commands LM MG SG
LM
S-meter reading and squelch status.
The LM command is used to report the S-meter level and squelch open / closed
status.
The S-meter reading is reported in 64 steps (hex) 00 ~ 3F. The squelch is
CLOSED when the response is 80 and above.
LC1B_RF0145300000
LC04_VA0128800000
2
3
4
5
6
7
- 22 -
Advertisement
Table of Contents
