AOR CU8232 Manual page 31

PI : PR
PI
Set interval time for power save mode.
The PI command is used to set the interval time and is used in conjunction with PA
which sets the delay time for the power save facility.
The command PI[ ] checks the current setting of power save delay time, the
response being PIn where n = 1 ~ 9 seconds
To change the current setting, use the PI command followed by a single digit
numeric value between 1 ~ 9, the value is in seconds.
To set an interval of 5 seconds use the command PI5[ ]
(Please refer to page 97 section 16 of the AR8000 English language operating
manual).
Related command PA
PR
There are 50 PASS frequencies allocated per search bank, they may be recalled
on an individual basis for review using the PR command before being deleted
using the PD command.
The BN or SS commands must be used to choose the bank prior to using the PD
command.
PRnn[ ] recalls a specific PASS frequency from the chosen search bank
where nn is the PASS channel number 00 ~ 49.
When a PASS channel is deleted using the PD command, the PASS frequency
number will be incremented upward.
Related commands BN PD PS PW SG SR SS
- 31 -