Table of Contents
Advertisement
(1) General
The CU8232 interface allows computer control via the RS232 serial port of a
computer. An additional piece of software will usually be required in order to
address the computer's serial port with the correct set of parameters. If using
an IBM-PC or clone (with 80386 processor or higher) Microsoft WINDOWS
"TERMINAL" may be used to address the computer's serial port, configuration
of "TERMINAL" is covered later in this manual.
In order to gain the greatest flexibility, a specialist software package is desirable.
It is planned to later introduce a Microsoft WINDOWS package to support the
AR8000 receiver.
The CU8232 interface also enables data to be copied between two AR8000
receiver when simultaneously connected to the CU8232. Memory, search and all
data may be transferred enabling full CLONE of one receiver onto another. This
may be accomplished without the use of a host computer and the interface is
powered from the AR8000 receiver.
(2) Supplied Accessories
Please check that the following items are included in the package:
Description
CU8232 remote control interface box
Flat cable
RS232C 9-pin to 25-pin adaptor
RS232C 9-pin male-Female adaptor
English language operating manual (this booklet)
(3) AR8000/CU8232 connection & clone
1. A ribbon cable is used to connect the AR8000 to the CU8232. One end of the
ribbon cable has a reinforced plate, this is used at the AR8000 end of the
connection. Insert one flat cable (they are both identical) into the CU8232
[PROGRAM] socket contact (metal) side downward.
General : Accessories : Connection & clone
- 3 -
Quantity
One
Two
One
One
One
Advertisement
Table of Contents
