Command Index - AOR CU8232 Manual

Command index

(9) Command index
AT Register the attenuator position ON/OFF.
AU Register the auto mode ON/OFF.
BM Register the scan bank link ON/OFF.
BN Change the search/scan bank.
BQ Register the search bank link function ON/OFF.
BS Register the search bank link ON/OFF.
DD Recall the VFO mode.
EX End the Remote mode (RS232C).
GA Register the select scan channel from Memory channel.
GD Delete the select scan channel from Memory channel.
GR Recall the select scan channel.
LC Respond with the received freq and S-level when SQ opens.
LM Respond with the S-level reading and SQ open/close.
MA Respond with the contents of the present bank or specified
bank.
MC Select the monitor switch position.
MD Select the receive mode.
MG Start the scan mode. Respond with receive freq and S-level
reading when SQ is open (as LC).
ML Register the scan bank link function ON/OFF.
MP Register the present memory channel as Pass channel.
MQ Delete the present bank or memory channel.
MR Switch to the memory read (M.RE) mode.
MS Switch to the scan (SCAN) mode.
MX Write data into memory channel.
PA Register the delay time of Power Save mode.
PD Delete the Search Pass Freq
PI Register the interval time of Power Save mode.
PR Recall the Search Pass Freq
PS Register the Search Pass Freq
PW Register the presently receiving freq as Pass Freq
RF Key in the Freq in VFO
RX Respond with the presently receiving data
SA Register the Audio Search ON/OFF.
SB Register the Level Search ON/OFF. Set the S-level.
SC Change the operating code of the option unit (when fitted - not
available in the UK).
SD Change-over HOLD/DELAY in Search mode. Register the delay
time.
- 14 -