Saving Changes; Connecting To Your Wireless Network - Cisco RV215W Administration Manual

Introduction

Connecting to Your Wireless Network

Connecting to Your Wireless Network
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV215W Wireless-N VPN Firewall Administration Guide
Other Resources
Support
Forums

Saving Changes

When you finish making changes on a configuration page, click Save to save the
changes in flash memory, or click Cancel to undo your changes.
To connect a client device (such as a computer) to your wireless network,
configure the wireless connection on the device with the wireless security
information you configured for your device using Setup Wizard.
The following steps are provided as an example; it might be necessary to
configure client device differently. For instructions that are specific to the client
device, consult the device documentation.
Open the wireless connection settings window or program for your device.
Your computer might have special software installed to manage wireless
connections, or you might find the wireless connections under the Control Panel in
the Network Connections or Network and Internet window. (The location
depends on your operating system.)
Enter the network name (SSID) you chose for your network in Setup Wizard.
Choose the type of encryption and enter the security key that you specified in
Setup Wizard.
If you did not enable security (not recommended), leave the wireless encryption
fields that were configured with the security type and passphrase blank.
Verify your wireless connection and save your settings.
Click to open the Cisco support page.
Click to visit Cisco online support forums.
4
13