Wall Mounting The Digital Telephone - Vodavi Starplus Triad 1/2/3 Installation Manual

Wall Mounting the Digital Telephone

Wall Mounting the Digital Telephone
To wall mount the Digital Key Telephone, it is necessary to use the Wall
Mount bracket and one standard-type jack assembly designed for normal
wall hanging applications. Refer to
1. Remove the handset from the cradle and locate the plastic retainer in
2. Turn the telephone over and unplug the line cord. If the line cord is
3. Line up the hooks on the top and bottom of the wall mount bracket
4. Match the two key hole slots on the base plate with the lugs on the
5. Place the handset onto the retainer. The telephone is now ready for
the bottom of the hook-switch well area. Push the plastic retainer
slowly upward until it is free. Locate the tab on the plastic retainer
and make sure the tab is toward you, then place it back into its holder.
Slide the plastic retainer all the way down into its channel. Part of the
retainer remains above its holder to hold the handset secure for the
wall mount configuration.
not plugged into the wall jack assembly, re-route the line cord thru
the access channel on the top of the telephone. If the line cord is
plugged into the wall jack assembly, run the line cord through the
hole provided and plug into the connector on the back of the
telephone.
so they can engage with the slots cut into the bottom of the
telephone base. Insert the bottom hooks first. Slide the mounting
bracket slowly downwards until the top tabs slide into the top slots
and snap in place.
630-A type jack. Align the modular connector and slide the telephone
into place.
use. Refer to Figure 3-37
Figure 3-36
for location of mounting information.
and Figure 3-37.
3-89