Miscellaneous Interface Unit (MISU) Installation
Installing the Serial Interface Unit (SIU)
1. Unpack the SIU from its antistatic conductive bag in the packing box.
2. Push the two standoffs into the holes on the SIU board. (Refer to
3. Locate the CONN1 connector and the two screw holes (outlined) on
4. Push the SIU board onto the CONN1 connector and be sure it is
5. From the back side of the MISU board, insert the two metal screws
There should also be a plastic bag with two plastic standoffs and two
metal screws.
Figure
2-14.)
the MISU.
seated correctly.
into the holes and tighten them into the bottom of each standoff to
secure.
This completes the installation procedure for the SIU.
2-31