Vodavi Starplus Triad 1/2/3 Installation Manual page 228

Remote System Monitor
1. To enable an Event Trace, type t<space> (space bar).
2. Then type of trace desired [d], where d is determined as follows:
3. Then enter the specific board, CO line or Station number of the trace
B = Board event trace (traces events associated with PCBs)
M = Miscellaneous State event trace
P = Pulse Coded Modulation (PCM) traces events associated with
voice communications
C = CO Line (LCOB) States (traces events associated with CO Line
activity)
S = Station (STA) States (traces events associated with Station activity)
E = Error Messages (traces error messages)
Q = Queue (QUE) Events (traces queuing events, e.g.: DTMF receiver,
UCD, LCR, etc.)
D = Device Command (traces commands to peripheral devices).
desired or type all, if all board's, CO line' s or Station's events are
desired.
1–31 = Board KSU card slot position (CPU = 1)
001-144 = CO Line port
100-351 = Station location
All = All Boards, CO lines or Stations
5-25