Mounting The Expansion Cabinet (Eksu1) - Vodavi Starplus Triad 1/2/3 Installation Manual

3-8

Mounting the Expansion Cabinet (EKSU1)

If required, an Expansion KSU1 (left top cabinet) is mounted directly on
the top of the Basic KSU.
Before mounting the Expansion KSU on the screws:
1. Remove the KSU Interconnect Cable Cover Plate on the top at the rear
2. Remove the two screws holding each plate and lift the plate from the
The EKSU1 is mounted in a manner similar to the BKSU.
1. Place the EKSU1 on the BKSU and mark the location of the four
2. Drill pilot holes in the four locations marked, insert and tighten the
3. Mount the Expansion KSU1 on the screws and tighten the screws
4. Mount the 4 side brackets between the Basic and Expansion KSUs.
Figure 3-2: BKSU Mounting Holes
right of the Basic KSU.
BKSU. Refer to Figure
mounting screws.
screws leaving about ½ inch exposed.
securely.
KSU & Power Supply (PSU) Installation
3-2.