Pcb Installation; Pcb Handling & General Installation - Vodavi Starplus Triad 1/2/3 Installation Manual

2-22

PCB Installation

PCB Handling & General Installation
All Boards SHOULD NOT be Installed or Removed with Power Applied.
Power must be turned off prior to insertion or removal of the PCBs.
The system PCBs contain digital circuitry which, while extremely reliable,
can be damaged by exposure to excessive static electricity. When
handling PCBs, a grounded wrist strap should be used to protect the
boards from static discharges. Also, use common sense when handling
PCBs. For example, do not place a PCB in locations where heavy objects
might fall on the PCB and damage components.
Inserting a PCB
1. Hold the PCB by the injector tabs and, with the components facing
2. Slide the card into the system and use the injectors to seat the PCB
Removing a PCB
Reverse the Inserting a PCB procedure. Installation method of PCB is
shown in
There is a ground tab located on the top and bottom of each PCB toward
the front end of the card. There is also a ground tab located to the right of
each card guide in each cabinet. Make sure when the PCBs are inserted
into the card guide and secured in their respective card slots, that the
ground tab on each card mates with the ground tab on each card guide.
This ensure a good ground potential to reduce RFI and EMI interference
possibilities.
Only DTIB type stations can be used for Database programming.
right, align the top and bottom edge of the PCB in the card guides.
firmly into the backplane connector.
Figure 2-11.
PCB Installation