Table of Contents
Advertisement
2-8
KSU & Power Supply (PSU) Installation
The
exterior of the
Mounting the
The Basic KSU is a metal frame cabinet designed for wall mounting.
Employing the KSU mounting template provided with the BKSU, mark
the location of the two screws to mount the BKSU. Again, the KSU must
NOT be mounted on a masonry or dry-wall surface, in this case a wooden
back-board is required. Refer to the next diagram for the distance
between mounting holes.
The BSKU is mounted with four #10 or larger, 1 ½ inch or longer screws.
1. Drill pilot holes in the two locations marked, insert the screws and
2. Mount the Basic KSU on the screws and tighten the screws securely.
3. Remove the front cover by turning the two cover screws counter
4. Tilt and lift the cover to remove.
5. Insert the screws to the mounting holes of the BKSU and tighten the
Triad 1
System consists of a Basic KSU (BKSU) cabinet. The basic
Triad 1
Triad 1
Basic KSU
tighten leaving about ½ inch exposed.
clockwise.
screws as shown.
KSU & Power Supply (PSU) Installation
System is shown in
Figure
2-2.
Advertisement
Chapters
Table of Contents
Troubleshooting
