Vodavi Starplus Triad 1/2/3 Installation Manual page 82

Station Connections
Installing the DTRU Module
1. Unpack the DTRU Module from its antistatic conductive bag in the
2. Locate the CON1 and CON2 connectors on the DTRU module.
3. Locate the CONN1 and CONN2 connectors on the SLIB (outlined).
4. Position the DTRU module so that the CON2 and CON1 connectors
5. Push the DTRU module onto these connectors making sure it is
Installing the MSGU Board
The Message Wait Lamp Relay Control (MSGU) provides Message Wait
Lamp Relay Control for message lamp single line telephones. The MSGU
board mounts on the SLIB board as a daughter board type arrangement.
1. Unpack the MSGU Module from its antistatic conductive bag in the
2. Locate the CONN1 and CONN2 connectors on the MSGU module.
3. Locate the CONN3, and CONN4 connectors on the SLIB (outlined).
4. Position the MSGU module so that the CONN1 and CONN2
5. Push the MSGU module onto these connectors making sure it is
packing box.
match up with the CONN1 and CONN2 connectors on the SLIB
respectively.
seated properly.
Refer to Figure 2-23. This completes the installation procedure for the
DTRU Module.
packing box.
connectors match up with the CONN3 and CONN4 connectors on the
SLIB respectively.
seated properly.
Refer to Figure 2-23. This completes the installation procedure for the
MSGU Module.
2-61