Modify Memory Command - Vodavi Starplus Triad 1/2/3 Installation Manual

5-26
4. Then press <
5. To disable or turn off a particular trace mode, DO NOT ENTER a
6. To have event traces displayed on the screen, you must first exit the

Modify Memory Command

The Modify Memory Command is for Engineering Use only.
r>
to enable the trace. A similar screen displays:
Figure 5-7: Enable Event Trace
specific board, CO Line, or Station Number (i.e.,
t<space>s<return> to disable station event trace).
MONitor mode by typing X at the mon> prompt. After you exit the
event(s), the trace begins as shown in
Unless instructedby personnelat
trace mode enabled forextended periods of time. The system dumps the
requested event(s) trace which may use up paper or fill memory buffers
on the collecting device. It is recommended that the trace events be
disabled (turned off) for all event(s) traces before leaving the system site.
Use of this command can alter or damage the
operating database, which can result in system malfunction. If this
occurs it is necessary to power the system down and re-initialize the
database, thencompletely reprogramthecustomerprogramming data.
Remote System Monitor
Figure 5-8.
VOD AVI Technica l Support
Triad 1/2/3
,do notleave the
System's