Mco Trunk Access - Panasonic S-ICX Technical Manual

Chapter 7. SLT Features
• N/A

MCO Trunk Access

The System supports up to 5 MCO groups for each MCO tenant group. You can seize an idle trunk
from the MCO trunk group by entering the MCO access code.
Operation
To seize an idle trunk:
1. Lift the handset.
2. Enter the desired trunk access number (9 [UK/HK], 0 [Tai-
wan, Malaysia, Indonesia], or 81-84). (See Table 24 on page
306.)
3. Dial the phone number.
Hardware Requirements
• N/A
Related Programming
• FF1: MCO Access
• FF5-2: MCO Trunk Group (Outbound)
• FF7: ARS/TRS (Call Barring)
Considerations
• The System supports up to 576 outside lines in a six-CCU configuration. These lines can be
divided into 99 different trunk groups.
• Each trunk group can support up to 50 outside lines.
• Each MCO Tenant Group can have up to 5 MCO trunk access codes. System defaults for MCO
trunk access codes are displayed in the following table.
• MCO1 can have up to 5 trunk groups assigned by the Advanced Trunk Group feature.
• MCO1 access code is used for Automatic Route Selection (ARS) access code.
Table 24. MCO Trunk Access Codes
MCO Group
MCO1
MCO2
MCO3
MCO4
MCO5
306
Action
Trunk Access Code
(UK/HK) or (Taiwan,
9 0
Malaysia, Indonesia)
81
82
83
84
S-ICX (International) issued October 2000
Section 700 - Operation
Result
Intercom dial tone
Outside dial tone
S-ICX-50-700