Conference Calls - Panasonic S-ICX Technical Manual

Chapter 6. DSLT Features
To set Manual Camp-on:
1. Lift the handset or press the ON/OFF key.
2. Dial the extension number.
3. Enter the Camp-on (Call Waiting) code (default = 2 [UK/
HK] or 2# [Taiwan, Malaysia, Indonesia]).
4. Remain on the line until the called party answers.
To answer a Camp-on (Call Waiting) signal:
1. Replace the handset or press the ON/OFF key.
2. Lift the handset or press the ON/OFF key again to be con-
nected to the waiting call.
OR....
Press the HOLD key.
Hardware Requirements
• N/A
Considerations
• You can transfer an outside call to a busy extension using Camp-on. See "Camping a Call Onto a
Busy Extension" on page 234.

Conference Calls

Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
Any combination of extensions and trunk lines can be in the conference as long as the original
extension is in the conference and the total number of parties does not exceed 8. Only one operation is
used to establish and add to a conference. You simply have to place the current call on hold, dial the
next party and press the CONF key. No different operation or access code is required to add
additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party

conference calls:

• 3 extensions
• 2 extensions and 1 trunk
236
Action
Action
S-ICX (International) issued October 2000
Section 700 - Operation
Result
Intercom dial tone
Busy tone
• Called party hears alert tone
• Calling party hears ringback tone
Result
• Current call placed on hold
• Connected to waiting call
S-ICX-50-700