System Speed Dial - Panasonic S-ICX Technical Manual

Section 700 - Operation
• Speed dial numbers can contain up to 24 characters. The following table reflects which keys to
use.
To indicate. . .
Digit or character
Intercom Level *
MCO Code 9 (UK/HK), 0
(Taiwan, Malaysia, Indonesia)
**
MCO Code 81**
MCO Code 82**
MCO Code 83**
MCO Code 84**
Pause
DP - DTMF Code
SSD Code
Hyphen (-)
Display Number (Start / Stop)
***
DTMF Conversion After the
Other Party Answers
* Indicates that the digits that follow are either a feature access code or an extension
number. (Not needed if your System is set for Intercom Level.) See Note below.
** Indicates that the digits that follow are for an outside number and the System should
seize the next available trunk when dialling. (Not needed if your System is set for trunk
level.) See Note below.
*** Indicates that the enclosed digits should not be displayed during dialling. Must precede
and follow the digits that you do not want displayed. Example: MEMORY *2 555-
4143 MEMORY *2.
Note: The System has two levels - Trunk Level and Intercom Level. If set at Trunk Level
(default), you must enter the code for Intercom Level when programming a feature access code
or extension number for speed dialling. If the System is set at Intercom Level, you must enter the
MCO Code when programming an outside number for speed dialling.

System Speed Dial

You can store frequently called numbers using the SSD feature. Either 80 or 800 SSD numbers can be
programmed, depending on how the System is configured. In an 80 SSD-number system, the SSD
numbers are stored in bins 00-79. In 800 SSD-number systems, the SSD numbers are stored in bins
000-799.
S-ICX-50-700
Enter/Press
0, 1 - 9, *, #
MEMORY * #
MEMORY * 0
MEMORY * 71
MEMORY * 72
MEMORY * 73
MEMORY * 74
FL/R
MEMORY * *
MEMORY
NN(N)
PROG
MEMORY * 2
MEMORY * 3
S-ICX (International) issued October 2000
Chapter 5. Key Telephone Features
Shown on Display?
yes (unless preceded by MEMORY * 2 - see
below)
no
no
no
no
no
no
no
no
no
-
189