Panasonic S-ICX Technical Manual page 159

Section 700 - Operation
4. Press the FL/R key.
5. Enter the code to be programmed. (See Table 18 on page
160.)
6. Press the HOLD key.
7. Repeat steps 2-6 to program additional keys.
8. Replace the handset or press the ON/OFF key.
To assign Flexible Feature Codes to an FF key:
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key to be programmed.
4. Enter the code to be programmed. (See Table 18 on page
160.)
5. Press the HOLD key.
6. Repeat steps 2-5 to program additional keys.
7. Replace the handset or press the ON/OFF key.
To erase a code stored on an FF key:
Note: You cannot use the following procedure to clear FF keys that have been assigned as trunks.
Trunk keys can only be cleared through system programming.
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key that was programmed.
4. Press the HOLD key.
To check a programmed FF key (Display Phone Only):
1. Lift the handset or press the ON/OFF key.
2. Press the CONF key.
3. Press the FF key to be checked.
4. Replace the handset or press the ON/OFF key.
S-ICX-50-700
Action
Action
Action
Action
S-ICX (International) issued October 2000
Chapter 5. Key Telephone Features
Result
Programmed code displays
Programmed function name displays
Result
Intercom dial tone
F displays
Enter Function# displays
Programmed code displays
Programmed function name displays
Result
Intercom dial tone
Programmed code displays
Cleared Function displays
Result
Intercom dial tone
C displays
Programmed data displays
159