Verifying The Phone Startup Process - Cisco 7970G Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Verifying the Phone Startup Process

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
OL-11524-01
Figure 3-3 Parts Used in Wall Mounting the Cisco Unified IP Phone
1 Footstand adjustment button—Raises and lowers adjustment plate
2
Wall mounting screw holes
3 Adjustment plate—Raises and lowers phone vertically
After the Cisco Unified IP Phone has power connected to it, the phone begins its
startup process by cycling through the following steps.
These buttons flash on and off in sequence:
1.
Headset. (Only if the handset is off-hook when the phone powers up. In
–
this case, hang up the handset within 3 seconds or the phone launches its
secondary load instead of its primary load.)
– Mute.
Speaker.
–
Verifying the Phone Startup Process
3-15