Understanding The Cisco Unified Ip Phone 7970G/7971G-Ge Components; Network And Access Ports - Cisco 7970G Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phone
7970G/7971G-GE Components

Network and Access Ports

Handset
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
OL-11524-01

Understanding the Cisco Unified IP Phone 7970G/7971G-GE Components

The Cisco Unified IP Phone 7970G/7971G-GE includes these components on the
phone or as accessories for the phone:
Network and Access Ports, page 3-5
•
Handset, page 3-5
•
Speakerphone, page 3-6
•
Headset, page 3-6
•
The back of the Cisco Unified IP Phone 7970G/7971G-GE includes these ports:
Network port—Labeled 10/100 SW on the Cisco Unified IP Phone 7970G
•
and 10/100/1000 SW on the Cisco Unified IP Phone 7971G-GE
Access port—Labeled 10/100 PC on the Cisco Unified IP Phone 7970G and
•
10/100/1000 PC on the Cisco Unified IP Phone 7971G-GE
Each port supports 10/100 or 10/100/1000 Mbps half- or full-duplex connections
to external devices. You can use either Category 3 or 5 cabling for 10-Mbps
connections, but you must use Category 5 for 100 and 1000 Mbps connections.
Use the SW network port to connect the phone to the network. You must use a
straight-through cable on this port. The phone can also obtain inline power from
a switch over this connection. See the
page 2-4 for details.
Use the PC access port to connect a network device, such as a computer, to the
phone. You must use a straight-through cable on this port.
The handset is designed especially for use with a Cisco Unified IP Phone. It
includes a light strip that indicates incoming calls and voice messages waiting.
"Providing Power to the Phone" section on
3-5