Overview Of Options Configurable From A Phone - Cisco 7970G Administration Manual

Overview of Options Configurable from a Phone

Overview of Options Configurable from a Phone
Note
Table 4-1 Settings that You can Change in the Network Configuration Menu
Category Description
DHCP settings Dynamic Host Configuration Protocol
(DHCP) automatically assigns IP address to
devices when you connect them to the
network. Cisco Unified IP Phones enable
DHCP by default.
IP settings If you do not use DHCP in your network, you
can make IP settings manually.
TFTP settings If you do not use DHCP to direct the phone to
a TFTP server, you must manually assign a
TFTP server. You can also assign an
alternative TFTP server to use instead of the
one assigned by DHCP.
VLAN settings Allow you to change the administrative
VLAN used by the phone.
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
4-6
The settings that you can change on a phone fall into several categories, as shown
in Table 4-1. For a detailed explanation of each setting and instructions for
changing them, see the
There are several options on the Network Configuration menu and on the Device
Configuration Menu that are for display only or that you can configure from
Cisco Unified CallManager. These options are also described in the
Configuration Menu" section on page 4-7
Menu" section on page
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
"Network Configuration Menu" section on page
and the or the
4-15.
Network Configuration Menu Option
DHCP Enabled
DHCP Address Released
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP Server 1
Alternate TFTP
TFTP Server 2
Admin. VLAN ID
4-7.
"Network
"Device Configuration
OL-11524-01