Setting For The Lan To Connect The Multiple Units - Sony BVN-L230 Operation Manual

If 4 Asia Except Japan is selected:
Select Area
Asia Except Japan
NTSC Area
PAL Area
Customers who will use this monitor in the shaded
areas shown in the map below should select NTSC
Area.
Other customers should select PAL Area.
Then press the ENTER (Ent) button.
3
Confirm the settings.
Select Area
XXXXXXXXXX
Color Temp:
Setup Level:
Component Level:
Color Gamut Emulation:
Cancel
Confirm
Cancel: Select to cancel the setting and return to the
Select Area screen.
Confirm: Select to save the setting and end selecting
the area.
See "Default value for each area" on page 27 on the
setting value.
28
Settings
NTSC area
B
B
PAL area
xx
xx
xx
xx
After saving and reflecting the setting, you can change the
setting with the menu.
• Color Temp (color temperature) (page 53)
• Setup Level (NTSC Setup Level: page 55, Betacam
Setup Level: page 55)
• Component Level (page 55)
• Color Gamut Emulation (page 57)
Setting for the LAN to Connect the
Multiple Units
You can control the multiple monitors using the controller
connected via each LAN (10/100) connector. You can also
control a specific monitor or monitor group.
Set an IP address to the monitors and the controller and a
monitor ID number and group ID number to each monitor.
1
Set the NETWORK switches of each monitor and the
controller to PEER TO PEER.
PEER TO
PEER
NETWORK
LAN
NETWORK
LAN
2
Set the different IP address to each monitor and the
controller.
Monitor: Set the IP address in the Network Setting
menu of the System Configuration menu (page 70).
Controller: Set the IP address in the Network Setting
menu of the Controller menu (page 80).
3
Set Monitor ID and Group ID in the Network menu of
the System Configuration menu (page 70).
Set the different monitor ID number to each monitor
and if necessary, group ID number.
You can use the numbers 1 to 99 as a monitor ID
number or group ID number.
PEER TO PEER